Land Rover Series 2/2A Engine Blue

SKU: 5005
From

£16.25Excl. VAT

£19.50Inc. VAT

Authenticated shade from original components. In Gloss Engine Paint enamel.

Description

Land Rover Series 2/2A Engine Blue. This is the colour used on Series 2/2A 2.25 litre Petrol and Diesel engines between 1960 – 1971. During the cross over from the Series 2 2 litre and Series 2A 2.25 litre, if a reconditioned, or new replacement cylinder head was fitted, these tended to come painted in the new 2.25 engine blue instead of the earlier 2 Litre engine grey.

Paintman Paint’s Engine Blue shade was matched against an original 2.25 petrol engine from the early 1960s, and checked against a 2 litre engine retro-fitted with a reconditioned Cylinder Head later in it’s life. This head was as stated in the later colour. The accuracy of the colour shade was corroborated by a Series 2 Club member, who was present at the time of the final colour shade decision.

Type of Paint

Paintman Paint take pride in only producing the highest quality, hand-mixed paints. Combining premium tints and resin in our formulas develops a paint with outstanding coverage, build and durability; suitable for the finest of projects.

Our mission is to provide paint that is as close to the original shades as possible. Please be aware, shades may differ depending on viewing device.

Land Rover Series 2/2A Engine Blue is available in Engine Paint Gloss formula only. This allows for higher heat resistance up to 170 degrees c, suitable for engines. 

Additional information of interest

  • Spray application. All of our Enamels will need to be diluted by around 5-10% using Paintman Coach Enamel Thinners, thus ensuring the highest quality finish and maintaining correct drying times.
  • Surface Preparation. Prior to painting ensure all surfaces are clean and dry to remove any contaminants. We recommend using our Surface cleaner 2800 for painted surfaces or our Surface Cleaner 2802 for bare metal. Surfaces should be keyed at each layer to maintain adhesion. Just prior to painting, wipe the surface with a Tack Rag to remove dust and other loose contaminants.
  • Aerosols. Aerosols in all colour variants are available. Special order aerosols are subject to a minimum order quantity of 4, you can order these directly  here.
  • Painting tips and advice. Check out our methods of use page, FAQ’s or YouTube Channel for lots of hints and tips. Alternatively, ask us your question on our Contact page.

Coverage

Brushing/Rollering: 8 sqm per 1 Litre (1 coat)
Spraying: 10 sqm per 1 Litre (1 coat)
Aerosol: 2 sqm per 400ml Can (1 coat)
Approximate

Bear in mind, we recommend completing your project with 2 coats of top coat to build a lasting, deep finish.

Estimated paint required for specific vehicles:

  • Land Rover
    • Short Wheel Base:
      • Outside: 2.5L or 15 aerosols
      • Inside & Outside: 3.5L
    • Long Wheel Base:
      • Outside: 3.5L
      • Inside & Outside: 4.5L
    • Wheels:
      • 1L or 2/3 aerosols
    • Roof:
      • 1L or 3 aerosols
  • VW
    • Camper:
      • 2 tone: 2 x 2.5L
      • 1 tone 5L

Drying Times

  • Traditional Synthetic Coach Enamel
    • Touch Dry 3hrs @20°C
    • Hard Dry 12hrs @20°C
    • Full Dry 24hrs @20°C
    • Recoatability After 24hrs
  • Ultraspeed Enamel – Spray Only
    • Touch Dry 2hrs @20°C
    • Hard Dry 8hrs @20°C
    • Flash Off time 20mins
    • Recoatability Min 24hrs depending on build & temp. Surface should be denibbed prior to overcoating.